|
|
Reporter | mlampert | Assigned To | mlampert | |
---|
Priority | normal | Severity | minor | Reproducibility | always |
---|
Status | closed | Resolution | fixed | |
---|
Product Version | 0.18 | |
---|
Target Version | 0.18 | Fixed in Version | 0.18 | |
---|
|
|
Summary | 0003490: Post processing always insterts TC even though it hasn't changed |
---|
Description | Noticed that multiple `M3` and `M6` commands were in a g-code file although there was only a single TC in the job. Checking the code it seems this came in through a refactoring quite a while ago, although the intended behaviour has always been to only insert TC commands on change. |
---|
Steps To Reproduce | Create a job, one tool and two operations.
When exporting the Job through post processing and count the number of `M6` and `M3` commands (should be one). |
---|
Tags | No tags attached. |
---|
|
|
FreeCAD Information | |
---|
|
|