FreeCADView Issue Details
| ID | Project | Category | View Status | Date Submitted | Last Update |
|---|---|---|---|---|---|
| 0004128 | TechDraw | Feature | public | 2019-09-13 11:49 | 2022-01-15 15:39 |
| Reporter | wandererfan | Assigned To | wandererfan | ||
| Priority | normal | Severity | minor | Reproducibility | have not tried |
| Status | feedback | Resolution | open | ||
| Platform | all | ||||
| Target Version | 0.20 | ||||
| Summary | 0004128: Allow Angled Section Views | ||||
| Description | Forum discussion Currently, the Section tool will only create sections in 4 directions (left, right, up, down). There are occasions where a Section at an angle (say 45*, left/down to right/up) to the Base view would be useful. | ||||
| Additional Information | There was a question about this in the German forum some time ago. German forum thread re angled Section | ||||
| Tags | No tags attached. | ||||
| FreeCAD Information | |||||
|
|
This can be accomplished by changing the Direction and SectionNormal properties of the SectionView after it is created. |
|
|
Is this request still valid given the ability to adjust the direction after creation? |
|
|
This ticket has been migrated to GitHub as issue 5988. |
| Date Modified | Username | Field | Change |
|---|---|---|---|
| 2019-09-13 11:49 | wandererfan | New Issue | |
| 2019-09-13 12:09 | wandererfan | Additional Information Updated | |
| 2021-02-06 06:38 | abdullah | Target Version | => 0.20 |
| 2022-01-15 15:37 | wandererfan | Note Added: 0016215 | |
| 2022-01-15 15:39 | wandererfan | Assigned To | => wandererfan |
| 2022-01-15 15:39 | wandererfan | Status | new => feedback |
| 2022-01-15 15:39 | wandererfan | Note Added: 0016216 |
