|
|
| Reporter | sliptonic | Assigned To | | |
|---|
| Priority | normal | Severity | minor | Reproducibility | N/A |
|---|
| Status | new | Resolution | open | |
|---|
| Product Version | 0.20 | |
|---|
| Target Version | 0.20 | |
|---|
|
|
| Summary | 0004558: Helix operation should handle conical use-cases |
|---|
| Description | Current helix operation can only handle cylindrical holes. It should also handle conical holes.
|
|---|
| Additional Information | Ideally, it would have a very similar interface to the new additive/subtractive helix sweep in PD. Even better, it should autoconfigure based on the selected geometry. |
|---|
| Tags | No tags attached. |
|---|
|
|
| FreeCAD Information | <!--ATTENTION:
COMPLETELY ERASE THIS AFTER PASTING YOUR
Help > About FreeCAD > Copy to clipboard
NOTE: just the snippet alone will do without anything else included.
The ticket will not be submitted without it.
--> |
|---|
|
|
FreeCAD